Comafast AC1200 Quick Start Guide

Technical parameters:

Hardware:RTL8881AN+RTL8192ER chip solution.

Wireless Transmission Rate:1200Mbps
Radio frequency: 2.412~2.4835 GHz,5.180 ~ 5.825 GHz
Wireless Standard:IEEE802.11ac/a/b/g/n
Voltage:100~240V,50/60Hz

Connect with the SERIUD Installation Assistant

① Plug the extender into an electrical outlet proximity to the WiFi router or access point and wait for the Power Lamp to light on.

② Search and connect to the extender WiFi network“COMFAST_xxxx_2G”or “COMFAST_xxxx_5G” in your wireless network list with a laptop or smartphon. Get either of 2G or 5G set up, then the other will be set up successfully at the same time. And you can connect either of 2G or 5G to access the internet.  

Note: Keep your smartphone or laptop being connected to the extender during the installation.

③ When the extender is connected for the first time, the management interface will pops up automatically. If not, launch a web browser and enter 192.16 8.10.1 in the address field.  Enter "admin" in the account and password field, click LOGIN  .

④ Enter the default password admin and click Login.

⑤ It will scan the wireless network signals around.

⑥ Select the WiFi network you want to extend. In the Password field, type the existing
WiFi network password and click the Apply button.

⑦ After the installation is complete, it will reboot automatically.

⑧ Then connectyour new extender SSID and enjoy the WiFiThen connect your new extender SSID and enjoy the WiFi.

⑨ Unplug the extender and move it to a new location that is about halfway between your router and the area with a poor router WiFi signal. The location that you choose must be within the range of your existing WiFi router network.

⑩ Use the Power Lamp on the front panel to help you choose a spot where the extender-to router connection is optimal.The light is green with good signal and red with weak signal. Locate it several times to find the optimal location.

⑪ Reconnect your WiFi device to the new extended WiFi network.